How do resistive type fuel level sensors work?

by MShakeG   Last Updated May 22, 2020 21:25 PM

Resistive type fuel level sensors which are used in fuel storage tanks(such as those at fuel stations) comprise of 2 visible parts; dual probe rods and a connecting float.

When the float is at the very bottom the output of the sensor is Vmin(possibly ~0V) and as the float progressively approaches the top the output increases upto Vmax(possibly ~Vsupp).

I would like to understand how these sensors work possibly by a simple circuit model?

For example:
XM/XT 66400 Series Continuous Level Transmitter(note the dual rod/probes)
enter image description here

Tags : resistors sensor


Answers 1


I'm taking a guess based on the type your describing. The long probes with a magnetic float has a resistor tree wired in series with reed switches.

It has been a while since I pulled one down for repair but believe each resistor / reed was wired in parrellel. When the magnet was over a reed. That circuit was closed and the resistance of the sender decreased. Usually in the range of 10-220 ohms for the ones i dealt with.

Here is a link that has pictures to go with my explanation

https://www.reed-sensor.com/help-support/level-sensing-circuits/

A 500mm long sensor had 22 switches from memory. Its not linear but steps.

Some car manufacturers such as ford took this a bit furthur and included an amplifier on top of the reed switch sender to convert it to a voltage for the engine ecu.

Reroute
Reroute
May 22, 2020 21:08 PM

Related Questions



searching for a specific impact force sensor

Updated October 06, 2017 18:25 PM



Force Sensitive Resistor OverLoad

Updated September 05, 2017 09:25 AM