S parameters LT SPICE

by Anirudh Roy   Last Updated June 12, 2019 07:25 AM

I read the help section on .net and found that i can use either a node (Vout) or a resistor (I(Rout)) to specify the output node. However the 2 give me different values of S parameters for the below cct.


For this the value of S11 was -868.46102mdB. While for the directive .net I(R2) Vs the value of S11 was -827.8537mdB which is the correct value. Can someone explain why?

Related Questions

import touchstone file into ltspice

Updated June 13, 2019 15:25 PM

How should I simulate a s-parameter model in LTspice?

Updated October 19, 2017 08:25 AM

F-parameters instead of S-parameters

Updated January 21, 2019 18:25 PM

Measure 4-port device with 2-port VNA

Updated March 06, 2018 12:25 PM