simulator error when I try to get the frequency response in proteus

by Ananya1   Last Updated June 12, 2019 06:25 AM

I want to get the frequency response of a notch filter circuit in Proteus 7. The simulation gave good result. The hardware implementation also worked fine. When I tried to get the frequency response, error messages came up saying

i) AC analysis is not supported [refering to the oscilloscope]

ii)simulation failed due to simulator errors.

I would like to remind that the simulation worked and the digital oscilloscope showed expected waveform. The error log is attached below.

enter image description here

The schematic looks like this:

enter image description here

I cant figure out my mistake.

Thank you in advance

Related Questions

Passive Elements At high Frequency [parasitic effects]

Updated December 08, 2018 00:25 AM

Frequency Variation of Lamp

Updated October 05, 2018 06:25 AM