What configuration is needed to use an ATMega328p micro-controller on a breadboard

by Liro   Last Updated May 23, 2019 16:25 PM

I previously bought an Arduino Uno that came with a store bought/prebuilt PCB and ATMega328p to program it and use the pins. I also have a second ATMega328p that was bought by itself and I successfully bootloaded it to be compatible with my prebuilt PCB so that I could program it.

However, when I try to use either ATMega328p's on just a simple breadboard, neither of them work or output anything meaningful, regardless of how simple a program I make(like the simple LED example given with the Arduino IDE).

enter image description here enter image description here

I used these two configurations which should be very similar and it still did not work. I did not include the FTDI serial chip as I wasn't going to use Rx and Tx pins. The 16MHz oscillator, capacitors, and resistors were used as well

How do I use the ATMega328p outside of the store bought/prebuilt PCB?



Related Questions





bitbang atmega328 with arduino bootloader using avrdude

Updated September 12, 2017 19:25 PM

ATMEGA328p-AU BootLoader

Updated March 16, 2019 19:25 PM