Doubt about focusing in the lens?

by sat   Last Updated June 18, 2017 05:18 AM

I usually find after blowing out my pic in computer that at one point (where I wished to focus) image is very sharp, then as I inspect the picture I see that some more part of the image either horizontally or vertically is in focus

My doubt is When we lock the focus at certain point, Is it that entire plane(both in x and y direction) is in focus, because I see most of the times(In Macro) , focusing is either horizontal or vertical or I have mistaken, because of minute difference in distance. eg.

                        (In focus)   
                            |
                            |
   (Not in focus )  ________|__________ (Not in focus or I have mistaken)
                            |
                            |
                            | 
                        (In focus)

And I understand a general statement that higher F-number means more area of focus.

Tags : macro focus


Answers 4


The focus plane is parallel to the plane of the sensor (or film), unless you're using tilt lenses.

If you're finding that parts of your image that are expected to be in focus are in fact out of focus, then they must lie on a plane that is tilted with respect to the camera.

In macro photography this is common, because it is quite hard to orient the camera precisely parallel to the plane you wish to shoot. The depth of field is so small with macro lenses at 1:1, that shooting at a high aperture (f/22 or higher) mitigates this effect.

Martin Krzywinski
Martin Krzywinski
July 11, 2011 07:27 AM

Not sure if I understood your question correctly, but if your photos have lines in one direction in focus but crossed lines at same distance out of focus, your lens suffers from astigmatic aberration - focal distances for the perpendicular lines are at different distances, which is caused by spherically asymmetrical or misaligned glass surfaces. Try another lens and see if the problem persists.

If you meant having a band of image in focus and adjacent areas out of focus, your lens is probably less corrected for field curvature aberration than you'd like - the lens projects a spherical image, but the sensor is flat. Along longer side of sensor, the difference may well exceed depth of focus and cause part of image be out of focus.

Imre
Imre
July 11, 2011 10:44 AM

Yes, the area that is on focus is a plane.

If you would take a picture of a wall, with the sensor exactly parallell to the wall, the entire wall would be in focus.

The DOF (depth of field), which is the depth of what's in focus, depends on the aperture (f-number) and the distance to the subject. In macro photo you are often very close to the subject, so you get a very narrow DOF.

When you have a narrow DOF, it's not easy to get the sensor plane parallel to what you want to catch in both x and y direction, so it's easy to get the effect where the DOF seem to be a horisontal or vertical band rather than a plane.

Guffa
Guffa
July 11, 2011 18:32 PM

When pushing a lens to the absolute limits, as you would in macro shots with the aperture wide open, you will notice even the smallest defects in a lens. No lens is perfectly shaped and there will be some distortion, though on the most expensive lenses, any distortion should be extremely small.

Additionally any misalignment in your set up would show as you describe. If the subject plane is not absolutely parallel to the focal plane then you will get a focus pattern as you described, where the line of focus runs along the axis of the misalignment. Using precision made mounts for the camera and the subject, such as those found in microscopes, would allow you to ensure that subject, lens, and camera body are truly aligned.

Rincewind42
Rincewind42
July 11, 2011 18:41 PM

Related Questions



Macro lens: IF or Extending Barrel?

Updated March 10, 2016 07:07 AM