The loop cut I make basically creates a plain outside the mesh.

by Robert Rex Courtis   Last Updated May 15, 2018 18:15 PM

So I was doing a tutorial, as you do, making an anvil. I removed a piece from the mesh using boolean. Then after making the loop cut to smooth out the edge, I found that the bottom portion of the loop went outside the mesh, as opposed to Guru's version in the tutorial (and apparently everyone else's in the comment section) instead of following the circular edge. I restarted from scratch making sure I don't push anything wrong and it still won't stay inside.

What am I missing? Could you please enlighten me?

enter image description here

Tags : modeling mesh


Related Questions



How to create a square in mesh?

Updated April 29, 2015 21:06 PM

Preserving shading after cutting a hole

Updated May 13, 2015 12:44 PM


How to slide geometry past an edge?

Updated April 14, 2015 20:06 PM